Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

Numerical study of enhanced energy dissipation near a seamount

Using a two-dimensional primitive equation model, we examine nonlinear responses of a semidiurnal tidal flow impinging on a seamount with a background Garrett-Munk-like (GM-like) internal wavefield. It is found that horizontally elongated pancake-like structures of high vertical wavenumber near-inertial current shear are created both in the near-field (the region over the slope of the seamount) and far-field (the region over the flat bottom of the ocean). An important distinction is that the high vertical wavenumber near-inertial current shear is amplified only at mid-latitudes in the far-field (owing to a parametric subharmonic instability (PSI)), whereas it is amplified both at mid-and high-latitudes (above the latitude where PSI can occur) in the near-field. In order to clarify the generating mechanism for the strong shear in the near-field, additional numerical experiments are carried out with the GM-like background internal waves removed. The experiments show that the strong shear is also created, indicating that it is not caused by the interaction between the background GM-like internal waves and the semidiurnal internal tides. One possible explanation is proposed for the amplification of high vertical wavenumber near-inertial current shear in the near-field where tide residual flow resulting from tide-topography interaction plays an important role in transferring energy from high-mode internal tides to near-inertial internal waves.     

一种推广的缓坡方程

从流体力学基本方程出发，假定水流的涡量和垂向流速分量小量，推导出考虑非均匀水流的推广的缓坡方程，该方程中包含了△h^2h项和（△hh)^2项。在方程中引入底摩擦项、风能输入项和非线性项，其中风能输入项的推导考虑了风浪与涌浪的区别，风流情况依据青岛海洋大学的风浪成长经验关系，涌浪情况依据Snyder等人的观测结果。经过上述推广后，得到综合考虑折射、绕射、反射、非均匀水流、底摩擦损耗、风能输入及波浪非线性的推广的缓坡方程。     

辽东湾S2冰侧限剪切强度的试验研究

利用试验方法系统地研究了辽东湾S2型海冰侧限剪切强度随剪切应变速率、加载方向、法向应力、温度和冰内孔隙率的变化规律。介绍了S2型海冰各向异性特点及剪切应变速率对剪切破坏方式的效应和韧脆破坏转变的条件。分析了不同加载方向海冰峰值剪切强度的差异 ,获得 - 6 2℃温度下S2冰内摩擦角和内聚力分别为 42°和 70 0kPa。利用统计分析给出峰值剪切强度与冰温和孔隙率的试验关系     

Gradation affects basic mechanical characteristics of Chinese calcareous sand as airport subgrade of reefs

Abstract

Construction of the reefs in the South China Sea is a significant foundation to the secure stability and economic development of China. The construction of an airport runway is necessary for this realization. The calcareous sand is the main primary material in the runway construction. A certain type of calcareous sand near a certain reef of the South China Sea was studied in this paper. To investigate this specific calcareous sand, quartz sand was used as a reference for comparison. Microscopic 3-D imaging, compression and triaxial tests were conducted to test the micro, squeezing and shear properties. The effect mechanism of gradation on the calcareous sand’s compressibility and shear characteristics are discussed from a mesoscopic viewpoint using 3-D morphology. Calcareous sand particles are multiangular and flatter in comparison with quartz sand. The larger the particle sizes are, the more different the two sands’ morphologies are. The compressibility of calcareous sand is greater, and the effect of the coarse fraction (5–1?mm) content in the gradation plays the most significant role in this feature. When the coarse particles’ content is less than 25% and the mass ratio of the middle and fine particles (M) is constant, there is the worst coarse fraction content causing the calcareous sand to be most likely compressed. The worst coarse fraction content decreases with the increase in M, and an empirical formula is proposed. When the gradation, relative density and confining pressure are the same, the peak shear stress and strain of calcareous sand are all at a high level. The effect of confining pressure is manifested in calcareous sand. The shear strength and dilation of calcareous sand are also most affected by the medium coarse fraction (5–0.25?mm) content.     

波浪物理模型试验中风速比尺确定方法初探

在波浪模型试验中研究风对构筑物的作用时,会涉及到风速比尺的确定问题。风对构筑物的作用力包括惯性力和粘滞力,这2种力的大小与建筑物的形态有关,对有的构筑物的作用力以惯性力为主,有的则以粘滞力为主。所以,在波浪物理模型试验中不能简单地采用重力相似准则也不能采用粘滞力相似准则来确定风速比尺。根据大量的试验研究结果,提出了采用不同模型比尺的船舶模型试验来确定风速比尺的方法,为波浪模型试验中风场模拟和数据处理提供了依据。     

Three-dimensional numerical simulation of obfique wave action on vertical walls

A three-dimensional numerical model based on the potential theory was developed to study the oblique wave action on vertical walls. A source term inside the domain was used to generate incident waves and outgoing waves were dissipated by sponge layers and transmitted by radiation boundaries. The finite difference method was used to solve the governing equations and boundary conditions in the regular transformed domain in σ-coordinate. Satisfactory agreements between the numerical predictions and experimental results of wave force were obtained. It is concluded that the maximum wave force acting on the vertical walls is induced by the obliquely incident waves rather than the normally incident waves.     

具有内波特性的渤海南部次重力波

次重力波(infragravity waves)是频率范围介于局地平均Brunt-V¾is¾l¾频率和0.05Hz(涌浪频率)之间的一种海洋波动,其能量在深水大洋中一般甚低,但在浅海中却很强.该波动的研究对于浅海海洋内部混合、近岸海洋工程、海洋生态学、海洋沉积学及军事海洋学均有重要的意义.Munk[1]很早就开始研究这类波动,然而主要由于观测技术的限制,对于该类波动的动力学机制的研究进展迟缓.